Clear the grime and refill every joint with new sand
Paver Cleaning and Joint Sand in St Augustine Beach, FL
Ask for a free paver cleaning and joint sand estimate in St Augustine Beach by calling (904) 719-7441.
- Brings out deeper paver color
- Fresh joint sand helps lock pavers in place
- Gives weeds less room to grow
- Makes the surface easier to keep clean
- Free estimate, no obligation
Request a Free Estimate
Free, no obligation.
Can I get my pavers cleaned in St Augustine Beach without a long wait?
A local contractor cleans pavers across St. Augustine Beach, FL, and the nearby counties, and you will hear back within 1 business day, usually much sooner. New joint sand is part of the job, and the estimate is free with no pressure to book. To start, call (904) 719-7441.
A cleaning takes off the algae, dirt and stains that make pavers look tired, so the surface brightens and feels safer to walk on. New sand then goes into the joints. That steadies the pavers and gives weeds less room. The back walk that turned dark over a damp summer can match the rest of the yard again. Point out the worst spots when you send the short estimate form.
Paver Sealing St Augustine Beach Is Proud to Serve Northeast Florida
What is part of a paver cleaning job?
Expect algae treatment, a gentle wash and new joint sand once everything dries. Book it by itself, or as the opening half of a sealing job. Shady walks and the ground around sprinkler heads usually take longest. To line up a cleaning, call (904) 719-7441.
Algae treatment
A bleach-based cleaner goes on first and is tested on a small spot. Western Interlock's care guide describes this approach.
Gentle wash
A rotary surface cleaner passes over the area with a wide nozzle, which keeps the spray from blasting sand out of the joints.
Fresh joint sand
Dry sand is swept into every gap once the pavers dry, then settled with a light mist of water.
Sealer if you want it
Sealer can go on after the surface has dried all the way. The sealing guide covers what it adds.
What are the signs my pavers need cleaning?
Signs include a green or black film along shady edges, dark streaks under drip lines, weeds in the joints and sand left on the driveway after rain. Algae tops that list, because a slick walk or pool deck can cause a fall. To have yours looked at, call (904) 719-7441.
Is cleaning enough, or should I seal my pavers too?
Think of a cleaning as fixing how pavers look today and a coat as deciding how long that look lasts. Stopping at a cleaning costs less now, but algae and fading return on their own schedule. A coat makes the next wash easier and needs renewing every two to three years, according to Safe Touch. Mention whether you want a coat as well when you send the short estimate form.
How often should pavers be cleaned in St Augustine Beach?
Once a year works for most homes, with spring the season Family Handyman suggests. A shaded walk or a patio beside a damp lawn may need attention sooner than a sunny driveway. For a schedule that suits your yard, call (904) 719-7441.
Does a harder blast clean pavers better?
No. Extra force does more harm than good. Western Interlock lists 1,500 PSI as the pressure to aim for, and Family Handyman says not to spray straight into the joints because that knocks the sand out. Ask which pressure and nozzle the contractor will use when you send the short estimate form.
The way the work is done matters about as much as the tools used. A rotary surface cleaner held at a steady height gives an even result, and the right cleaner does the heavy lifting in place of raw pressure. Ask how the contractor protects nearby plants, too. To raise those questions now, call (904) 719-7441.
Why does green film keep coming back on my pavers?
Moisture is the cause. Pavers in shade, near downspouts or inside a sprinkler zone stay damp for more of the day, and algae grows where it stays damp. Moving a sprinkler head or trimming a hedge can slow the return. A cleaning clears what is there, and sealing afterward can make the next wash easier. To plan around your yard, call (904) 719-7441.
What is the white film on newer pavers?
A white, chalky haze on newer pavers is usually efflorescence, which is natural salts working up out of the concrete. Unilock says to wait a season for it to finish before a sealer goes on. Cloudy old sealer can look almost identical. Point the spot out to the contractor when you call (904) 719-7441.
Which paved areas can be cleaned at a St Augustine Beach home?
The driveway, pool deck, patio and front walk can all be cleaned. Each picks up its own kind of grime, so the cleaner and the method differ. To start with yours, send the short estimate form.
Driveways
A driveway takes tires, oil drips and the longest hours of sun. Cleaning keeps the color even and the joints full, so pavers stay locked under a car.
Pool decks and lanais
A pool deck takes splashes, chlorine and bare feet daily. Cleaning should leave it drained, grippy and easy to rinse.
Patios and outdoor kitchens
Patios with shade and a damp lawn beside them grow green film early. Cleaning here is mostly about clearing that film and slowing its return.
Front walks and beach access paths
A walkway that carries sand in from the beach sees constant scuffing. Cleaning keeps the entry looking cared for, since it is what visitors step on first.
What leaves pavers dirty near the beach?
Sun fade, moving sand, green film, sprinkler marks and old sealer lead the list. Cleaning handles some of them, and sealing or repairs handle the rest. To check which ones fit your home, call (904) 719-7441.
1. Sun fade on open driveways
A driveway with no shade gets sun from morning to evening, and unsealed color turns chalky first there. A wash reveals how much color remains, and a coat afterward helps keep it.
2. Sand that moves
Beach sand blows onto walks and patios and scuffs the surface when it is swept or walked across. Summer storms also wash joint sand out, which Safe Touch lists as a common cause of loose pavers.
3. Green film in damp spots
Shaded corners, spots near downspouts and edges by a lawn stay wet longer. In a humid county, that is all algae needs to get a start.
4. Sprinkler marks
Irrigation that hits the same edge every morning leaves a line along walls and lower pavers. Those marks have to be treated before any coat goes over them.
5. Old sealer that has failed
Cloudy, peeling or patchy sealer cannot be coated over. It has to be stripped before pavers can be cleaned for good, which adds cost and time.
What does paver cleaning cost in St Augustine Beach?
No published cleaning only price for this area was found, so the honest answer is to ask for one in writing. Safe Touch publishes $1.75 to $3.25 per square foot for the full clean, sand and seal in Northeast Florida, and a wash with new sand and no sealer should come in below that. Compare what each quote includes, since joint sand and repairs are often priced apart. For a price on your property, send the short estimate form.
A single price for the wash, the sand and the coat is easier to compare. To go over both jobs with a person, call (904) 719-7441.
Want the pavers protected too? Read about sealing your pavers, check the towns served or head back to paver sealing in St Augustine Beach.
| Paved area | Typical example | Full clean, sand and seal |
|---|---|---|
| 500 sq ft | Walkway and entry | $875 to $1,625 |
| 900 sq ft | Large driveway | $1,575 to $2,925 |
| 1,400 sq ft | Driveway and lanai | $2,450 to $4,550 |
Math uses the $1.75 to $3.25 per square foot that Safe Touch published for Northeast Florida, read in November 2026. A wash with new sand and no sealer costs less, but no published figure for that job was found for this area, so ask each contractor for it in writing.
Why use a local contractor for paver cleaning?
A contractor who works near the beach knows what damp lawns, sandy walks and sprinklers leave behind. Compare the quote with the range printed on this page, and decide whenever you are ready. To begin, send the short estimate form.
A contractor who works the coast
A company that covers St Augustine Beach already deals with strong sun, ocean air and wet summers. That makes the first visit more useful.
A free look and a free number
The visit and the estimate cost nothing. If the number does not work for you, say no and owe nothing.
Prices you can check
Northeast Florida companies post what they charge per square foot, and this site shows that range. A quote far above or far below it deserves a question.
You set the pace
Get everything in writing and take your time. The contractor standards page covers what to confirm before you sign.
Want a free estimate to clean your St Augustine Beach pavers?
Use the form or call, and a local company gets back to you within 1 business day, usually much sooner.
Free, no obligation
What do freshly cleaned pavers look like in St Augustine Beach?
How does the paver cleaning process go, step by step?
If no sealer is booked, the visit ends after step four, when the joints are full. To set a date, call (904) 719-7441.
1. Measure and inspect
The contractor measures the area for the cleaning quote and notes sunken spots, cracked pavers, old sealer and any place where water sits.
2. Cover and wash
Plants, screens and doors get protected and the sprinklers go off. A rotary surface cleaner with a wide, gentle nozzle washes the pavers while the joint sand stays put.
3. Treat what is left
Green film gets a bleach-based cleaner, which Western Interlock's care guide describes. Rust and other stains get their own cleaner, tried first on a small spot.
4. Refill the joints
After the pavers dry, fresh sand is swept in, settled with a mist of water and topped off. Full joints are what keep pavers locked in place.
5. Seal and walk it through
When sealer is part of the job, it goes on dry pavers with a sprayer, a roller or both. Last, the contractor walks the area with you and says when feet and cars may go back on it.
Frequently Asked Questions
How much is it to clean pavers?
No cleaning only price for this area was found, so ask each contractor for one in writing. The full clean, sand and seal runs about $1.75 to $3.25 per square foot, based on Safe Touch, and a wash with new sand and no sealer should come in below that.
Can I clean, sand and seal my pavers?
Yes, and that is how a full job is done: clean first, refill the joints once the surface is dry and then seal. Safe Touch warns that a coat over dirt or damp pavers is how jobs go wrong. The coat goes on last, on a dry surface.
Is it a good idea to pressure wash pavers?
Yes, with low pressure and a wide nozzle. Western Interlock lists 1,500 PSI as the target, and Family Handyman suggests a white 40 degree nozzle and says not to spray straight into the joints. Fresh sand goes in after the wash.
Should pavers be sealed after they are cleaned?
Not always, but the joints do need fresh sand. A coat afterward holds that sand through summer storms and makes the next wash easier. It also becomes a repeat job every two to three years, which Safe Touch calls typical.
How often should I clean my pavers in St Augustine Beach?
About once a year, and Family Handyman suggests spring. Shaded walks and damp edges near the lawn may need it sooner. A sunny driveway can often wait.
Why do my pavers keep turning green in St Augustine Beach?
Shade, humidity and sprinklers keep the surface damp, and damp is what algae needs. Trimming back plants and aiming sprinklers away from the pavers helps. A bleach-based cleaner, which Western Interlock describes, clears the film that is already there.
What is the white film on my new pavers?
It is most likely efflorescence, salts that rise out of new concrete. Unilock says to wait a season for it to finish before sealing. A cleaning removes the film for now, and it can return until the process runs its course.
Ready to see clean, even pavers at your front door?
Call or send the form, and you get a reply within 1 business day, usually much sooner.
Free, no obligation